ApplicationEspecially developed for use on pipe material and curved surfaces, for unalloyed and alloyed steels, non-ferrous metals, plastics and GFRP.
For material thicknesses up to 4 mm (3/16 inch); stainless steel up to 2 mm (1/16 inch).
Recommended for use on hand drills up to max. diameter 40 mm (1.9/16 inch) or stationary machines.
Execution- The hole saw is manufactured from a single piece for diameters from 15.2 mm (3/16 inch) to 30.0 mm (1.1/8 inch)
- A special hardened holder is used for diameters from 31.0 mm (1.3/16 inch) to absorb torsional forces under heavy load and thus avoid premature shearing of the drive arbor
- Carbide-tipped
- Tapered centre drill bit with pre- and post-cutter, replaceable
Advantage- High concentricity thanks to stable construction
- CAD-optimised chip angles with special grinding surface ensure high cutting performance and long service life
- Fast core removal by means of ejector spring
- Carbide tips allow repeated regrinding
- Repairable: Teeth can be replaced if they break
Delivery1 hole saw
1 centre drill bit
NotesWhen spot drilling pipes, drill with low contact pressure and avoid pendulum motions
For greater material thicknesses: Cut 2-3 mm (1/16-7/64 inch) in each work step, then remove the chips
A high-quality cutting oil should be used when sawing metals
Exceptions: Do not use cutting oil for cast iron and use petroleum instead of oil for aluminium
Note: Always wear safety goggles!
Special designs for special applications are available on request!