ATORN slotted vacuum plate set SV3 400x300x32.5, average slot spacing 5 mm

Application
Ideal for light machining tasks such as milling or drilling - e.g. printed circuit boards or electronic components - or also engraving. It is thus also possible to securely clamp workpieces that are much smaller than the clamping surface of the vacuum plate. Workpieces no larger than a postage stamp can be cut out of larger material sections using milling techniques. Individual adaptation to part geometry ensures reliable clamping of almost all conceivable workpiece geometries.

Execution

• The narrowing of the cross section within the Venturi pipe causes a vacuum here, which draws the air in.
• Depending on the application, the clamping plate surfaces are equipped with slots. Rubber adapter mats or cover films are required for clamping workpieces that do not occupy the entire plate surface.
• The noise level is just 57 db (A).
• Vacuum generated by pneumatic vacuum ejector: max. vacuum approx. 5-6 bar. End vacuum of up to 87 % depending on conditions of use. Air consumption approx. 90 l/min.
• Vide généré par l'éjecteur à air comprimé : vide environ 5-6 bar max. Vide final jusqu'à 87 % selon les conditions d'utilisation. Consommation d'air env. 90 l/min.

Advantage

• Low overall height.
• Wide range of applications through the use of rubber adapter mats.
• Can be used in the HSC (High Speed Cutting) area for milling small contours with the help of plane-parallel rubber adapter mats suitable for milling.
• Clamping of very small workpieces is possible.
• Venturi technology requires little maintenance.

Delivery
1 vacuum slotted plate, 2 adjustable clamps, 1 hose connection for quick-action coupling, 3 m pneumatic hose, 1 red rubber adapter mat, 1 connection for conventional vacuum pump.

Notes
Conversion set for wet machining included in scope of delivery. A vacuum pump is also needed for wet machining.